TenaControls ARPLN-A Generic Airplane Light Kit for use in any Airplane (Complete Kit). Add life to just about any Airplane model you are planning to build. All the connections to these boards are done to the 8 wire mating connectors, no soldering (to the control board).This board comes with pre-wired on/off micro slide switch for turning power to the board ON or OFF. The 9 volt battery connector is also pre-wired, and if you want to run it on 12 VDC, you can.This board has two modes, a single wing strobe with standard light sequence or the A320 Airbus mode with double wing strobe, upper and lower beacon lights, tail strobe light and Red and Green steady ON navigation light. Includes: One (1) fully assembled board – just connect the LED’s. One (1) battery clip for 9 volt battery. One (1) White 3mm led. Two (2) Red 3mm led’s. One (1) Red SMD pre-wired led. One (1) Green SMD pre-wired led. Two (2) White SMD pre-wired LED’s. Miniature 8 wire JST connectors. Best warranty in the business – 5 Year Warranty -volt battery holder and micro On/Off slide switch, which turns the car light board on or off, to the board for your convenience. You just need to plug the eight-wire JST connector into the mating connector on the board and connect the LED to its corresponding wire coming from the eight-wire JST connector. The magnetic reed switch allows you to toggle through all the light modes, just by using the enclosed supplied magnet. This feature allows for the car to stay intact, with no holes for a momentary switch (on plastic model cars). What’s included: One (1) fully assembled board – just connect the LED. One (1) battery clip for 12 12-volt battery and a 12-volt battery., One (1) on/off switch wired to the board., One (1) magnetic reed switch. One (1) magnet. Shrink tubing. Red, Orange and White LEDS. Miniature eight-wire JST connector. Best warranty in the business – 5 Year Warranty (for warranty claims, the buyer should contact TenaControls directly)., Model kit not included
