TenaControls MEGA-1701-R Star Trek Enterprise 1701 Mega Board to control every lighting segment on the 1/350 Scale Refit. This is the complete controls and weapons board you will ever need. The Mega-1701-R is now available to light up the entire 1/350 Scale Refit in a timed fashion as stated below. This kit is designed to allow you the ability to change the flash rates on the Navigation Lights and Strobe Lights, which are stored in memory. The next time you turn the ship on it will come up with the rates you set. Additionally, you can set three Modes of operation, drydock, Movie and Flight mode. The Drydock and Movie modes also has a DEMO Mode, which will shut down the entire ship and bring it back up in sequence. All the connections to these boards are made to the Micro JST Connectors, there will be no soldering on the control board at all. This is why we say this is the complete board. The board is designed to provide all Navigation Lighting, all Strobe Lighting, Navigational Deflector Dish, Side Deflector Dish Lights, Impulse Crystal, Impulse Engine, Landing Bay Sequential Landing Lights, Raytheon Lights, Bridge Light, Lower Dome Lights, RCS Thrusters Lights, Saucer Window Lights, Neck Interior and Exterior Lights, Secondary Hull Interior Lighting, Pylon Lights, Landing Bay Interior Lights and the Nacelle Chiller Grills. How this board functions: The above elaborates on the overview of the functions, although the manual will go into detail on what you can achieve with this system. As mentioned before, this is a complete system all on One Board. Along with the above functions, this board also has Photon Torpedo’s and Phaser weapons effect with built-in audio sounds, which can fit inside the Secondary Hull if you wish to place the board inside your ship. Although for most, placing in the base will be easier. As always, TenaControls uses commercial-grade components in all our controls for reliability and longevity. There are just too many components you will receive to list below, be assured you will receive all the LED’s, LED Strip Tape, Speakers, Momentary Switches, Resistors, wiring, and shrink tubing. This board will work on 9 to 12 volt DC supply with 2 Ampere rating. Model kit not included. (for warranty claims, the buyer should contact TenaControls directly)
